EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: JMcC on May 10, 2021, 08:42:20 pm
-
I'm guessing this is a long shot, but I'm desperate....
I have an Advantest TR6847 DMM with a TR 13217 GPIB interface installed. I'd like to connect this to a PC, but have no info on the programming commands for it. I'd be grateful if someone could please point me in the right direction. I had a good search of the net, but so far nothing useful.
Thanks,
Joe
-
Curiously I found it by searching for the TR6845 manual! https://www.eevblog.com/forum/repair/advantest-tr6845-calibration-procedure-and-error-message-need-help/ (https://www.eevblog.com/forum/repair/advantest-tr6845-calibration-procedure-and-error-message-need-help/)
Joe