EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: attie on March 03, 2013, 07:24:17 pm

Title: Agilent 2000 X-Series Signal Generator Issues
Post by: attie on March 03, 2013, 07:24:17 pm
Hi All,

I was using the siggen in my scope today, and found some issues.
I've documented them in the videos below, and included a quick round-up too:


Has anyone else found these issues? Has anyone found solutions?
I wonder if Agilent will offer a solution to this... hopefully it's a firmware issue and that trigger output isn't genuinely put through a comparator...

Agilent 2000 X-Series SigGen Issue (https://www.youtube.com/watch?v=tksFOyKK4kU#ws)
Agilent 2000 X-Series SigGen Trigger Output Issue (https://www.youtube.com/watch?v=zVoNY9OUGp0#ws)