Products > Test Equipment
Agilent 54835A scope (4 channel 1GHz / 4Gs/s) repair & uphack
<< < (79/80) > >>
Tony_G:
You can just change the drive letter used by MSCDEX in autoexec.bat - "/L:F" will mount the drive to F: - You might be able to use "assign" to redirect F: to the cdrom drive but it really is just easier to change the letter in autoexec.

I would simply write the Win98SE boot disk image to a floppy, change the letter to F, boot, and run cdromupg - You don't need to change anything on the device, just the boot floppy. You can then reboot and go back to whatever config you want.

TonyG


BoscoLab:
I finally finished the update on the HP 54845A, now it has A.04.50. Thanks for the help!  :)

Rudolf

Tony_G:
Good to hear - Glad I could help.

TonyG
ARF:
I'll update the topic. I recently received 54845A. At first glance, everything works, but during calibration I received an error on one channel. Any advices? I remember that in 54820 oscilloscopes it was necessary to clean the sockets for ADC modules.

nctnico:
You can try and clean the sockets but it is also possible the input module is defective.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod