Products > Test Equipment
Agilent DSO3102A UART Pinout
(1/1)
franksretrolab:
Hello, I have an Agilent DSO3102A that has stopped booting.
I am looking to connect a CH340 so that I can view the logs.
I searched through and read many forum posts, and the only one I could find a post that had a photo of the pinout for the 3000X.

I found a header on this board marked J12 and I tested a couple of the pins to ground to see if it was like the image and it was not. 
Pins 2 and 10 seem to go to ground....so I am trying to figure out which pins would go to Tx and Rx.
I have attached a photo of the board.

I am new to this so please forgive me if I am missing info, etc.

Any help would be greatly appreciated.
Thank you
DavidAlfa:
From the adsp-bf531 datasheet:

81 TX
82 RX

Try tracing those pins to the 14-pin header, seems to be routed there, also the JTAG interface.

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod