EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: egonotto on September 22, 2018, 03:09:27 pm

Title: Agilent DSO6104L - Boot data error occurred
Post by: egonotto on September 22, 2018, 03:09:27 pm

Hello,

I have a used DSO6104L since four weeks. Sometimes after turn on comes the message:
"
System conserns detected:

  - Boot data error occurred
  - The default setup was loaded
"

I have not found an explanation of this error.

What does this mean?
How can I repair the problem?

Best regards
egonotto

Title: Re: Agilent DSO6104L - Boot data error occurred
Post by: Carrington on September 22, 2018, 04:53:01 pm

Reload FW in this order: sys, lib, gsp, lpk.
Then, run a self test, and adicionally (if you can) do a self cal.