Products > Test Equipment
Agilent E4406A Vector Signal Analyser
<< < (8/22) > >>
KJDS:

--- Quote from: davorin on September 28, 2015, 02:54:25 pm ---Well I'm planning to use it privately....and secondly...the Tektronix is way out of Budget (o;

Would fit perfectly with my other "old" Equipment ;-)

--- End quote ---

YHM
davorin:
Hmm...people mention here that the SA part span is limited to 10MHz....
But on this Youtube video I see it set to 100MHz span....


Wuerstchenhund:

--- Quote from: davorin on September 28, 2015, 06:32:55 pm ---Hmm...people mention here that the SA part span is limited to 10MHz....
But on this Youtube video I see it set to 100MHz span....

--- End quote ---

That's with the W-CDMA option. Other options and Basic mode are limited to 10MHz.
davorin:
Makes perfectly sense then....the "W-" (o;

Still a nice and fast device...seems it is also running HP-UX 10.x?
Wuerstchenhund:

--- Quote from: davorin on September 28, 2015, 07:07:40 pm ---Still a nice and fast device...seems it is also running HP-UX 10.x?

--- End quote ---

HP-UX/RT, an embedded (cut down) variant of HP-UX 8.x or 9.x if I remember right. The firmware console is similar to later HP9000 PA-RISC workstations, i.e. the 712 Series. pr the 744 VME controller (which is basically what the controller in this thing is).

It's the same as Agilent's old high end Spectrum Analyzer series PSA (the E4406A is essentially a cut down PSA).
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod