Products > Test Equipment

Agilent E4406A Vector Signal Analyser

<< < (12/22) > >>

G0HZU:
I've used it OK with both GPIB and LAN.

GPIB is much easier to set up but with LAN you have to set up the IP correctly and I also used a crossover cable. You also have to install the correct registry update for the OS you are using. I use an old dual core laptop running WinXP with the E4406A and so I used the 32bit registry file.

There is also a 64 bit registry file for 64bit OS. Which are you using?

davorin:
Hmm...I'm using 64bit OS....

Just now removed the new Keysight IO lib and replaced it with the VSA 89600 supplied Agilent IO lib...
Now it checks both addresses during Startup, GPIB and LAN....

Crossover? What's that? (o;

I'm running my home network with several switches and dual SM fibre cables between rooms ;o)


So where can I find the 64-bit reg file Version?



davorin:
Found it...in the same Agilent forum topic as the last post (o;

Not sure if it will still work when replacing the Agilent IO lib with newer Keysight IO lib...

Here a quick AM modulated signal coming from a R&S SMT03...

davorin:
Experimenting now with the E4406A and the VSA software (o;

Haven't figured out yet how to capture and demodulate Microchip MiWi signals at 868MHz...think those modules default to OOK...

So which demodulator I have to choose? The only Thing coming close was RFID demodulator...as I haven't found any specific ASK/OOK demodulator.



fisafisa:
Hi.
I want to try this software next few days.
I have got a 4406A too, I downloaded the version 12 as per the link earlier in this forum.
Where is the patch?

Thanks

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod