Products > Test Equipment
Agilent E4406A Vector Signal Analyser
0xfede:
Hi folks,
another happy E4406A owner here. The one from EQT is arrived and is working fine despite the missing serial numbers.
When I'll have some spare time I'll give a shot to the 89601A which looks promising.
@fisafisa:
I found the registry fix on the keysight forum, precisely here:
http://www.keysight.com/owc_discussions/servlet/JiveServlet/download/83-18386-59940-3445/e4406.zip
fisafisa:
Thanks
fisafisa:
Will the software run in a virtual machine under linux?
If not it means resurrecting an old laptop!
0xfede:
Hi again folks.
I'm here because I'm getting trouble connecting the 89600 to the E4406A.
After all the installation I'm stuck with this message:
Cannot find a supported input. Option 300(Hardware Connectivity) is not installed on this system. Inputs will simulate an Agilent VSA E1439 70MHz IF 95Ms/sec ADC.
Of course I've added and successfully identified the instrument in Agilent Connection Expert and I see briefly it in the 89600 loading window just before the message.
My system is WIN XP 32bit SP2, E4406A Hardware is FW A.10.08
If I use SCPI commands via telnet it works fine.
Both TELNET and Socket ports are ON.
I've tried fresh windows installation with 89600 V9.02, V11.21, V12.02
I'm sure that I'm missing something, any help will be greatly appreciated.
Thanks,
0xFEDE
davorin:
What does "Help -> About Agilent VSA" show when you click then on the "boot log" button?
Did you install the Agilent IO lib with the 89600 software or was there a previous Agilent IO installation?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version