Products > Test Equipment
Agilent E4406A Vector Signal Analyser
<< < (17/22) > >>
asilva10:
Just received my E4406A today - not much experience in this area.
I would like only to use the Spectrum Analyzer portion to zoom-out details that my current SA (HP8590A) cannot reach at the same accuracy level.

My question is how to eliminate the green trace that basically follows the yellow? I know that they are related to I-Q stuff - someone can help me here with this basic stuff since I am just using the min RF inut port?

0xfede:
Just push the zoom button (below the screen). Then with the 'next window' button you'll cycle between IQ window and spectrum window.

Best,
0xfede
asilva10:

--- Quote from: 0xfede on January 18, 2017, 10:10:11 pm ---Just push the zoom button (below the screen). Then with the 'next window' button you'll cycle between IQ window and spectrum window.

Best,
0xfede

--- End quote ---

Hi Oxfede,

thank you. I did that and I have full screen with the spectrum but both traces (yellow and green) show up. I would like to see just one. We have some screenshots at this website showing this but I was not to do the same.
0xfede:
Then click the 'View/Trace' button, 'Trace Display' and select the 'Current' or the 'Average'.
asilva10:

--- Quote from: 0xfede on January 18, 2017, 10:27:19 pm ---Then click the 'View/Trace' button, 'Trace Display' and select the 'Current' or the 'Average'.

--- End quote ---

It worked!!  Thank you!!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod