Products > Test Equipment
Agilent E4406A Vector Signal Analyser
asilva10:
Just received my E4406A today - not much experience in this area.
I would like only to use the Spectrum Analyzer portion to zoom-out details that my current SA (HP8590A) cannot reach at the same accuracy level.
My question is how to eliminate the green trace that basically follows the yellow? I know that they are related to I-Q stuff - someone can help me here with this basic stuff since I am just using the min RF inut port?
0xfede:
Just push the zoom button (below the screen). Then with the 'next window' button you'll cycle between IQ window and spectrum window.
Best,
0xfede
asilva10:
--- Quote from: 0xfede on January 18, 2017, 10:10:11 pm ---Just push the zoom button (below the screen). Then with the 'next window' button you'll cycle between IQ window and spectrum window.
Best,
0xfede
--- End quote ---
Hi Oxfede,
thank you. I did that and I have full screen with the spectrum but both traces (yellow and green) show up. I would like to see just one. We have some screenshots at this website showing this but I was not to do the same.
0xfede:
Then click the 'View/Trace' button, 'Trace Display' and select the 'Current' or the 'Average'.
asilva10:
--- Quote from: 0xfede on January 18, 2017, 10:27:19 pm ---Then click the 'View/Trace' button, 'Trace Display' and select the 'Current' or the 'Average'.
--- End quote ---
It worked!! Thank you!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version