Products > Test Equipment
Agilent E7495 linux root account
Wuerstchenhund:
--- Quote from: 9aplus on November 08, 2015, 03:58:39 pm ---LCD Info from OM Serge @ HP/Agilent-Yahoo group
--- Quote ---It's a 10.4" VGA LCD from NEC:
NL6448BC33-50
--- End quote ---
--- End quote ---
Datasheet:
http://www.spectrah.com/product/lcd_panel/nec_lcd_panel/nec_NL6448BC33-50_tft_color_lcd_module_specification.pdf
9aplus:
Tnx @Wuerstchenhund
Have located few sources, prices going from USD200 to 380Euro
Just must first open my unit to verify model, just to be on safe side.
jwm_:
My LCD is undergoing the exact same thing, except is more further along than yours. Unit still works properly, but a good cm of the corners are now gone.
It almost looks repairable, like a gasket or something is being pushed over the lcd or behind the backlight. Have not tried to dissasemble it yet though.
sportq:
I just got one of these, an E7495A with all the hardware options except E1 tester. I tried to follow the instructions in post #22 to patch the /flash/egServer/elgato binary however it doesn't seem to work. In fact when I try to go to page 2 of 2 of the SYSTEM menu the device hangs. I've put it back to the original binary and the menu works again. Is there anything else that needs to be modified? It mentions editing the ]tt]elgato.lic[/tt] file but it's not clear what should be done. I'd really like to enable option 300, the DC Bias output.
I've also downloaded the Debian Woody (3.0) ARM iso to get some useful Linux binaries. So far I've extracted and tested busybox :-+ to test the process but I'll make an archive of useful ones (sshd would be great if it works). If any owners want something specific, let me know.
Lastly, I've contacted Keysight to see if they will release the Linux kernel .config file. It's a while since I hand-rolled a kernel but I'm sure I'll manage it. USB storage support would be very useful, even if it's only 1.0 (12Mbit/s).
Peter
PA0PBZ:
Hi Peter,
Do you have the correct firmware version? The patch is for version A06.25.
Did you find the to change bytes to be the same?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version