Products > Test Equipment
Agilent E7495 linux root account
<< < (62/91) > >>
9aplus:
So tomorrow morning I am in chase for 10 uF 35V tantalum.
Will report further development when replaced  ;)
kirill_ka:
Do you have a PIC programmer? Maybe you could download the firmware from your PSU board? I'd like to check if they fixed the SMBus code in newer revisions.
9aplus:
No PIC programmer at the moment. But can find one when done with this trouble...

Today browse through 3 local shops, some tantalum procured, but not the right one SMD 10 uF 35 V
So trial with:
SMD 4,7uF 50V
or
Pin through 10uF 35V
Must decide after removing of the blown one...
kirill_ka:
I'd stack two 4,7uF
9aplus:
Stacking was not feasible operation, therefore classic wire through component replacement.
Unit tested, red LED lit... looks good.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod