Products > Test Equipment

Agilent E7495 linux root account

<< < (62/91) > >>

9aplus:
So tomorrow morning I am in chase for 10 uF 35V tantalum.
Will report further development when replaced  ;)

kirill_ka:
Do you have a PIC programmer? Maybe you could download the firmware from your PSU board? I'd like to check if they fixed the SMBus code in newer revisions.

9aplus:
No PIC programmer at the moment. But can find one when done with this trouble...

Today browse through 3 local shops, some tantalum procured, but not the right one SMD 10 uF 35 V
So trial with:
SMD 4,7uF 50V
or
Pin through 10uF 35V
Must decide after removing of the blown one...

kirill_ka:
I'd stack two 4,7uF

9aplus:
Stacking was not feasible operation, therefore classic wire through component replacement.
Unit tested, red LED lit... looks good.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod