Products > Test Equipment

Agilent E7495 linux root account

<< < (67/91) > >>

technogeeky:

--- Quote from: kirill_ka on March 28, 2019, 01:30:15 pm ---Does anyone know, how to disable HW options? For instance, I removed the power meter board to add a second channel to the E4418B power meter.
I hacked some "registry" files to make it boot, but the power meter option is still there. I want to remove it cleanly.

--- End quote ---

I suppose I have a similar question about the T1 analyzer.

As far as I know, the only way to stop the (very) long T1 analyzer initialization process from going is to disconnect the hardware. Anyone else know a way to stop it while leaving the hardware unchanged?

kirill_ka:

--- Quote from: technogeeky on March 29, 2019, 10:42:33 am ---As far as I know, the only way to stop the (very) long T1 analyzer initialization process from going is to disconnect the hardware.

--- End quote ---
When I disconnected the power meter board, it didn't start. So I'm not sure if this is an option with the T1.
The service guide mentions some serial number editing utility which is used to enable HW options...

ogden:

--- Quote from: technogeeky on March 29, 2019, 10:42:33 am ---As far as I know, the only way to stop the (very) long T1 analyzer initialization process from going is to disconnect the hardware. Anyone else know a way to stop it while leaving the hardware unchanged?

--- End quote ---

Try removing hardware option from elgato.lic. The very beginning of this thread is about adding/hacking software options, maybe removal works same way..

darnelld:

--- Quote from: kirill_ka on March 29, 2019, 09:53:17 am ---pts/? serves the same purpose as ttyp?. I think the comment about ttyp is obsolete. Have you upgraded to 6.25?

--- End quote ---

Actually no, let me give that a try... just got a compact flash to install from

technogeeky:

--- Quote from: ogden on March 29, 2019, 12:09:35 pm ---
--- Quote from: technogeeky on March 29, 2019, 10:42:33 am ---As far as I know, the only way to stop the (very) long T1 analyzer initialization process from going is to disconnect the hardware. Anyone else know a way to stop it while leaving the hardware unchanged?

--- End quote ---

Try removing hardware option from elgato.lic. The very beginning of this thread is about adding/hacking software options, maybe removal works same way..

--- End quote ---

I should have said I tried this; this does not work.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod