Products > Test Equipment
Agilent E7495 linux root account
HandBuilt:
Hello all,
Thanks for all the info and help on this great unit.
Well I found out fixing the gasket creep on the screen is an easy fix! Took the front key panel off, removed a ton of small screws to get to the back of the LCD. More screws to get the bezel removed and out came the LCD display.
The plastic panel on the front is 170mmx225mm / 6.7"x 8.85" X.065" 1.7mm thick lexan.
They attached it to the LCD with a rectangular stamped double side black tape or gasket. it pulls in with age and heat I'd guess.
I ordered some precut 1/16 lexan from Ebay and reattached it with clear 3M tape.
Its perfect now!
Cheers
ddcc:
I made some more measurements on my E7495A, but unfortunately nothing on the one-port RF path appears to be obviously broken. Since this thread is getting a little long, I've made a separate post.
jujun:
Hello,
Is there a way to allow measurements (S11 and S21) under 375Mhz ?
It seems that nobody reported a working hack.
Thank you
9aplus:
Here doing that in old fashion (no hack & Max Hold on) way... with external RLB (S21) and signal generators (S21/S11).
RLB Eagle N5A 5-3000 MHz
SigGen ERASynth or MorFeus
ogden:
--- Quote from: jujun on November 09, 2019, 11:08:28 pm ---Is there a way to allow measurements (S11 and S21) under 375Mhz ?
It seems that nobody reported a working hack.
--- End quote ---
Such hack is impossible because hardware of the signal source is limiting factor here.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version