| Products > Test Equipment |
| Agilent E7495 linux root account |
| << < (84/91) > >> |
| kirill_ka:
Hi, There's no reason in trying to start elgato without all modules connected. In my case removing just the power meter board will cause it to stuck at the copyright screen. Unfortunately I don't have time to prepare any clear directions for you (enabling log, etc.). You should be able to find some clues in the thread. As I remember, you can access web pages by removing entry in the egServer/passwd (or you need to remove the file as whole, I don't remember). |
| pieroc91:
Thanks for your reply, i will check my modules to see if anything is faulty, it has already some bodge wires running along which don't seem original ones. Still do you know if there's a way to recover the Host ID? my license folder is completely empty. Thanks |
| kirill_ka:
--- Quote from: pieroc91 on June 15, 2021, 02:16:55 pm ---well on a closer look running elgato via telnet i found that i have license problems of which my elgato.lic is completely missing, replacing with a generic one from this post does not help since my hostID is other. is there a way to recover the hostID? --- Code: ---ElgatoManager::ElgatoManager instanceName elgatoMgr Welcome to the DMC Shell. Type 'quit' or 'bye' to exit. > DragonflyIO::waitForCTS() 5000 ms timeout: readyLevel=Open, ms elapsed since last write: 10711, read: 10711 DflyIO::write(buf=0xbffff8b0, length=4) waitForCTS() failed with error=0x810000 ElgatoManager::waitForLicenseReady() !!!!! Dragonfly expected but not found on port 4 after 90 seconds ElgatoManager::initialize() !!!! waitForLicenseReady() timeout #1, trying again ... ElgatoManager::waitForLicenseReady() !!!!! Dragonfly expected but not found on port 4 after 90 seconds ElgatoManager::initialize() !!!! waitForLicenseReady() timeout #2, trying again ... --- End code --- --- End quote --- Aha, that's something. I don't think that the hostid is a problem here. It just fails to communicate with the DSP board. All the device identification (IDs, HW options) are stored on the DSP board. So no surprise that license functions are trying to communicate with the "dragonfly" first. |
| pieroc91:
Sucess!! one of the serial cables that goes to the A3 board was misconnected on a previous repair, now it booted fine but with no options, still now on the menu i can look my host ID an i can create a new elgato.lic with the correct data! |
| 9aplus:
Any of the members here ever in need of ISO calibration for your E7495 ? I was surprised with price of calibration within EU/Germany... Agilent E7495 traceable ISO calibration (CW signals only; no digital modulation) 1.800 euro ;) Any suggestions ? |
| Navigation |
| Message Index |
| Next page |
| Previous page |