| Products > Test Equipment |
| Agilent E7495 linux root account |
| << < (17/91) > >> |
| The_Hari:
Hello Everyone, I have an e7495a from ebay and i'm very happy with it. My Questions are: 1. Is it possible to use SCPI over Lan? 2. There is also a Webserver, it asks for a Password but the root-or guest-password doesn't work. 3. Anyone an Idea, how to add other Modulations to the Generator? Thx to Alll for the nice Work on this Device till now :-+ |
| duggerd:
I bought one of these a few weeks ago, and through my searching around I have found the service manual for it, as well as the latest FW. The FW is the same for both the E7495A and E7495B models. Service Manual: https://www.w35ktn5.com/share/e7495serv.pdf Latest FW (A.06.25): https://www.w35ktn5.com/share/full625.zip The service manual details the installation of the FW as an upgrade (just unzip to a CF or PCMCIA card) and insert before boot. Then confirm the upgrade using the OK button. You can also do a fresh install by instead of pressing OK at the upgrade screen, press the bottom button on the right hand side of the screen, the one directly opposite the screen from the NO option on the analyzer. |
| The_Hari:
Thank you very much :-+ :-+ :-+ Feels a little bit faster with the new Firmware ;) My next Step will be a self-made Battery, because an original one is way too expensive. |
| duggerd:
--- Quote from: The_Hari on May 26, 2015, 11:09:13 pm ---Thank you very much :-+ :-+ :-+ Feels a little bit faster with the new Firmware ;) My next Step will be a self-made Battery, because an original one is way too expensive. --- End quote --- I was just going to make a battery that attaches to the back of the instrument and connects using the existing DC barrel connector. It would be interesting to make some batteries that use the SMBus protocol that are not the rare ones that it comes with. You could probably do it with some lithium primary cells and 3D printed endcaps along with a little controller board. It would probably be cheaper than the $200 that the replacement batteries are going for, even for one-offs. |
| realcastle:
Hello everybody In find very interesting this approach of Agilent E7495 ,specially getting access into ARM LINUX system as root. My problem is on CSA n1996a ,it works very well as guest-TELNET using "noname " password , but unfortunately telnet as root can not login using the E7495 "wh1skers" password. Could someone help me? Thank you. :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |