Products > Test Equipment

Agilent HP 54831D advice

<< < (7/8) > >>

Minsoon:
 :)
Hi..
I also installed win98, but the PCI Device Driver does not work properly.
Is there no way?

The photo shows the installed version.
This is a driver error in XP.

ARF:
Do you have photos of your motherboard and ACQ board?
And I don't understand what is your problem? Did you have a scope with win98 and reinstalled to winXP?

Minsoon:
Thank you for your answer.
When I first purchased it, sw ver 2.41 was installed in Win98. It works well.
I installed this with WinXp on a new HDD.
After installing SW 5.71, all drivers were installed automatically, but only the PCI Device caused a problem (exclamation mark in the device manager in the photo).
An installation error occurs with the 548xx.vxd file. (Photo attached)

I installed WinXp Pro Sp3.
The motherboard is the original VP22.
I will attach a photo of the ACQ board.

The photo is
    SW execution error after booting
    PCI DEVICE exclamation mark in Device Manager
    PCI DEVICE error status
    DRIVER INSTALLATION
    Install HP548XX.VXD --> Installation error   ==> I think this file does not fit XP.
    board pictures

help Me....

ARF:
It seems like, you installed just clean Win XP and separate Agilent drivers and a scope software. You might be did something wrong.
I sent you the Agilent Win XP HDD image. So, use, HDD Raw Copy Tool.
There are two partitions = the master and the factory recovery. Push and hold left CTRL button, turn on the scope and make factory recovery. After this the scope should work correctly. You need the factory recovery because the master partition contains the copy of 2 channel 54830B with calibration data. This calibration data will not work with your 4-channel scope.

The ACQ = the big board on the bottom side of the scope. I  asked about this photo..

Minsoon:
 :) :)
thank you
I will try installing again with the recovery image and post it later.
Thank you so much.. ^_^
 

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod