| Products > Test Equipment |
| All about Keithley DMM7510. Bugs and features, recipes, advice, notes. |
| << < (22/26) > >> |
| HighVoltage:
--- Quote from: kj7e on October 21, 2021, 01:09:08 pm ---Model DMM7510 Firmware Revision 1.7.10 is out. --- End quote --- How funny, in order to upgrade, we have to downgrade: :-DD Snip from the release notes: --- Quote ---When you load the 1.7.10 firmware into your instrument, system messages will display the firmware version as 1.7.1. This is only a cosmetic issue and does not impact the performance of the unit. Subsequent firmware upgrades will display a two-digit firmware version number. To install firmware version 1.7.10 on your instrument, use the Downgrade to older option from the front panel or use the downgrade remote commands. See "Upgrading the firmware" in your instrument's Reference Manual for more information. --- End quote --- |
| MegaVolt:
We also updated the datasheet. They have removed the accuracy values for the 10 megohm mode. |
| E-Design:
--- Quote from: HighVoltage on October 21, 2021, 02:04:50 pm --- --- Quote from: kj7e on October 21, 2021, 01:09:08 pm ---Model DMM7510 Firmware Revision 1.7.10 is out. --- End quote --- How funny, in order to upgrade, we have to downgrade: :-DD Snip from the release notes: --- Quote ---When you load the 1.7.10 firmware into your instrument, system messages will display the firmware version as 1.7.1. This is only a cosmetic issue and does not impact the performance of the unit. Subsequent firmware upgrades will display a two-digit firmware version number. To install firmware version 1.7.10 on your instrument, use the Downgrade to older option from the front panel or use the downgrade remote commands. See "Upgrading the firmware" in your instrument's Reference Manual for more information. --- End quote --- --- End quote --- Yeah, its a pretty poor choice of words for upgrading.. the reason downgrade option is recommended is that it will force the upgrade (rewrite firmware) activity regardless of the existing version. It should be thought of as 'Force upgrade" pretty amusing nonetheless.. :) |
| MegaVolt:
Tried the new firmware. I did not put the previous one, so the changes on both. Of the good. The captions on the charts became very nice. This is very nice! See picture. From the not so good. 1. I managed to hang the device 3 minutes after firmware update playing with it via the browser :)))))) 2. Histogram captions are replaced by XXX when they don't fit. It is an old problem, but I have not written about it yet. See the picture. 3. nothing else is fixed :( |
| kj7e:
Model DMM7510 Firmware Revision 1.7.12 https://www.tek.com/en/support/software/firmware/model-dmm7510-firmware-revision-1712-and-release-notes |
| Navigation |
| Message Index |
| Next page |
| Previous page |