Products > Test Equipment
allmax+ programmer
(1/1)
milesvile:
Hello everyone and I wish you a Happy New Year and much success in your work.

I have owned the ALLMAX+ programmer from EEtools for years, but due to the damage of the disk of my old PC, I lost the software. I love that long-standing tool very much, so I would like to ask for help. I need software for MS-DOS or WINDOWS to run it. Of course, good some kind of documentation would also come. I have a PC with MS-DOS and LPT on the board. Any help would be welcome. Thank you.
joeqsmith:
This thread demonstrates my programmer running with more modern PC. 

https://www.eevblog.com/forum/chat/printer-ports-for-the-modern-pc/msg1038631/#msg1038631

I had hacked the software to support the different printer port.  I also hacked it to support an 8051 and a different E^2 device.  I believe the attached is the last version EETOOLs released, no hacks.  Empnt is a third party driver I used to work around the direct I/O calls when NT was released.   I also attached the documents I had for it that may no longer be available.

Again, this programmer was damaged during a lightning strike and because no details about the design were released and it uses PALs, I recycled it.   

Good luck with your programmer.
joeqsmith:
After digging out the old discs and uploading them, I wanted to say thank you for reaching out to me in a PM and asking me to spend my time helping you.  I assume you got it all working or I would have received more PMs asking for additional help.   

As mentioned, poor etiquette and entitlement are the norm.   
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod