| Products > Test Equipment |
| Amplifier for Function Generator needed (500 mA) |
| (1/5) > >> |
| HighVoltage:
I am looking for a simple amplifier to gain the current output of a Keysight function generator. - Voltage output: 10V PkPk - Current output: 500 mA - Max Frequency: 100 kHz What do any of you use? What is of the shelf available? Any recommendations? I found the LPA01 from Newtons4th but what else is available that will not break the bank? |
| T3sl4co1l:
Almost any audio amp circuit or buffer IC will do. Building, or off-the-shelf, plug and go? Tim |
| HighVoltage:
Thanks, This is for official use and I need an amplifier with datasheet that can be calibrated. So, DIY is not applicable for this project. I just came across the RIGOL PA1011, a 10W Power Amplifier for around $ 400 May be this can work. |
| maukka:
Cheaper alternative but only up to 50kHz: https://www.ebay.com/itm/FeelTech-DC-power-amplifier-module-amp-driver-For-DDS-Function-signal-Generator-/132059122895 |
| JohnPi:
Does anyone have any experience with that one ? Is it current limited ? Is there just a stereo amplifier inside the box ? |
| Navigation |
| Message Index |
| Next page |