Products > Test Equipment

Amplifier for Function Generator needed (500 mA)

(1/5) > >>

HighVoltage:
I am looking for a simple amplifier to gain the current output of a Keysight function generator.

- Voltage output: 10V PkPk
- Current output: 500 mA
- Max Frequency: 100 kHz

What do any of you use?
What is of the shelf available?
Any recommendations?

I found the LPA01 from Newtons4th but what else is available that will not break the bank?

T3sl4co1l:
Almost any audio amp circuit or buffer IC will do.

Building, or off-the-shelf, plug and go?

Tim

HighVoltage:
Thanks, This is for official use and I need an amplifier with datasheet that can be calibrated.
So, DIY is not applicable for this project.

I just came across the RIGOL PA1011, a 10W Power Amplifier for around $ 400
May be this can work.

maukka:
Cheaper alternative but only up to 50kHz:

https://www.ebay.com/itm/FeelTech-DC-power-amplifier-module-amp-driver-For-DDS-Function-signal-Generator-/132059122895

JohnPi:
Does anyone have any experience with that one ? Is it current limited ? Is there just a stereo amplifier inside the box ?

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod