Author Topic: Protek B8110 function generator  (Read 2512 times)

0 Members and 1 Guest are viewing this topic.

Offline JoeyPTopic starter

  • Frequent Contributor
  • **
  • Posts: 321
  • Country: us
Protek B8110 function generator
« on: February 04, 2013, 07:41:40 am »
Anyone have experience with this generator? Besides overall quality, does it have a FAN?

I'm tired of listening to the fan in my other function generator (DS345) all day when I just need a simple low freq signal.

This one looks like it has quite a few features and decent performance for about $150 (new) on ebay. But, it is said to weigh 15 lbs, so I'm concerned that it might have a cooling fan. I couldn't find a picture of the rear, nor a power consumption spec.
 

Offline mcclain1126

  • Newbie
  • Posts: 1
Re: Protek B8110 function generator
« Reply #1 on: February 06, 2013, 11:33:32 pm »
I have 4 of these in a teaching lab that I run.  There is no fan.  The unit is a manageable size and easy to use.  The only drawback for me is I have had two fail on me in the last few years.  I think a couple transistors went bad and took a few resistors with it.  Just a little smoke.  I am not sure if  the cause is poor design, or improper use. My lab is mainly used by beginners and I have seen some unusual hook-ups. 
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf