| Products > Test Equipment |
| AN8008 US $19, 9999count, 1uV, 0.01uA, 0.01Ohm, 1pF resolution meter |
| << < (154/172) > >> |
| ebastler:
--- Quote from: wolferl1210 on July 31, 2018, 02:37:41 pm ---It's the first time that I re-solder SMD, but a do have a lot of experince in soldering. I use a solder ATTEN ST-80 station with temp setting, so what temp should I use for the 0805 caps? Is the tip (attached pic) OK for that job? --- End quote --- That tip looks like something my dentist would use... ;) If you have a pencil or fine chisel tip for your normal through-hole soldering, there is no need to buy a special one for soldering 0805 SMDs. The same considerations apply as for through-hole soldering: The tip needs to be fine enough to touch the desired solder joint only, but shold not be thinner than necessary (for good heat transfer). Just hold your pencil or chisel tip into the angle beween PCB and the side wall of the 0805, and you will be fine. Also, your temperature setting should be the same as for small through-hole components. |
| stj:
--- Quote from: exe on July 16, 2018, 01:41:39 pm --- --- Quote from: stj on July 16, 2018, 12:25:33 pm ---you do, it makes a bang or large crack sound! >:D --- End quote --- Considering the DMM itself costs just a bit more than a good HRC fuse, that's fine with me :). A single-use DMM... PS could you remind me why it should bang? I thought it has fuses on all ranges... --- End quote --- that's a common miss-understanding. meters only have fuses on the current inputs. |
| In Vacuo Veritas:
--- Quote from: stj on July 31, 2018, 06:09:48 pm --- that's a common miss-understanding. --- End quote --- Oh I think I met her once. ("miss-understanding"? Really? You guys invented the language, not sure what you're doing with it these days, though.) |
| Zimphire:
Buying better test leads also makes this DMM alot better.. |
| stj:
--- Quote from: In Vacuo Veritas on July 31, 2018, 07:26:07 pm --- --- Quote from: stj on July 31, 2018, 06:09:48 pm --- that's a common miss-understanding. --- End quote --- Oh I think I met her once. ("miss-understanding"? Really? You guys invented the language, not sure what you're doing with it these days, though.) --- End quote --- shouldnt you be speaking french? >:D |
| Navigation |
| Message Index |
| Next page |
| Previous page |