Products > Test Equipment
AN8008 US $19, 9999count, 1uV, 0.01uA, 0.01Ohm, 1pF resolution meter
<< < (160/172) > >>
floobydust:
Would you add some gold test leads?
AN8008 always has an ohm or two of resistance, you can't even check 100R resistors to 1%.
It's like toy multimeter for measuring resistance.
djos:

--- Quote from: floobydust on August 25, 2019, 05:05:53 pm ---Would you add some gold test leads?
AN8008 always has an ohm or two of resistance, you can't even check 100R resistors to 1%.
It's like toy multimeter for measuring resistance.

--- End quote ---

I mainly use it for checking continuity in new PCB designs and other basic tests in my study. For this sort of thing it's prefect.
exe:
What am I doing wrong? (factory calibration, no modifications except extra cap to smoth dc-dc regulator's ripple as was suggested somewhere)

Those are my daily drivers (along with  K2000), while 121GW sits in the drawer.

PS There is always a lot of bias about cheap equipment.
floobydust:
I've cleaned the shit rotary switch a few times, tried various contact cleaners and lubes to prevent oxide from building up but it keeps happening. I don't use this DMM much.
Made in USA multimeters are my daily drivers for obvious reasons.

Update: CAIG DeoxIT F5 which has Polyphenyl Ether (PPE) totally works :) and the switch works without hassles now.
exe:

--- Quote from: floobydust on August 25, 2019, 08:09:58 pm ---I've cleaned the shit rotary switch a few times, tried various contact cleaners and lubes to prevent oxide from building up but it keeps happening. I don't use this DMM much.

--- End quote ---

Interesting, I wonder if mine has different contacts and/or plating. I don't want to tear mine down yet because it works... I bought my dmms from aliexpress.

PS did you check your shunt with another dmm? Unlikely, but may be something wrong with it?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod