Products > Test Equipment
AN8008 US $19, 9999count, 1uV, 0.01uA, 0.01Ohm, 1pF resolution meter
floobydust:
Would you add some gold test leads?
AN8008 always has an ohm or two of resistance, you can't even check 100R resistors to 1%.
It's like toy multimeter for measuring resistance.
djos:
--- Quote from: floobydust on August 25, 2019, 05:05:53 pm ---Would you add some gold test leads?
AN8008 always has an ohm or two of resistance, you can't even check 100R resistors to 1%.
It's like toy multimeter for measuring resistance.
--- End quote ---
I mainly use it for checking continuity in new PCB designs and other basic tests in my study. For this sort of thing it's prefect.
exe:
What am I doing wrong? (factory calibration, no modifications except extra cap to smoth dc-dc regulator's ripple as was suggested somewhere)
Those are my daily drivers (along with K2000), while 121GW sits in the drawer.
PS There is always a lot of bias about cheap equipment.
floobydust:
I've cleaned the shit rotary switch a few times, tried various contact cleaners and lubes to prevent oxide from building up but it keeps happening. I don't use this DMM much.
Made in USA multimeters are my daily drivers for obvious reasons.
Update: CAIG DeoxIT F5 which has Polyphenyl Ether (PPE) totally works :) and the switch works without hassles now.
exe:
--- Quote from: floobydust on August 25, 2019, 08:09:58 pm ---I've cleaned the shit rotary switch a few times, tried various contact cleaners and lubes to prevent oxide from building up but it keeps happening. I don't use this DMM much.
--- End quote ---
Interesting, I wonder if mine has different contacts and/or plating. I don't want to tear mine down yet because it works... I bought my dmms from aliexpress.
PS did you check your shunt with another dmm? Unlikely, but may be something wrong with it?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version