Products > Test Equipment

Aneng AN8008 multimeter fuses

<< < (7/9) > >>

floobydust:
I think it's the chinesium plating, it oxides and makes crappy contact. The slit makes a sharp edge that chews up banana plugs I find.
These pics of "gold" banana jacks are just sleeves. Probably plated steel.
A rich man would find Mill-max or something that ends up costing more than the DMM.
The AN8008 rotary switch is still shit, it's always oxidizing and not reliable.

stj:
a lot of those are gold plated copper,
but they are still solder-mount.

you need to use gold plated leads too,
if you dont, galvanic corrosion will get you - same goes for using gold leads in tin-plated sockets.

tcottle:

--- Quote from: stj on January 14, 2019, 02:54:28 pm ---

--- End quote ---

This appears to be the supplier  https://www.warwickts.com/1341/3265-I-4mm-Banana-Socket-with-M4-Threaded-Stud

Any idea where I can order in the US?

Candid:
You get these sockets from Hirschmann (brass, gold plated, AC/DC 1000V, 32A, CAT II, contact resistance 5mOhm, threaded connection) e.g. at RS components. The black one has order no. 972354-100 (other colors red -101, blue -102, yellow -103, green -104 and yellow/green -188 and some more colors). And there is a version with 6.3 x 0.8 tab connector (order no. 972356-1..). With the order no. it should be easy to find other suppliers.

stj:
the image is directly from Rapid Eelectronics.
https://www.rapidonline.com

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod