| Products > Test Equipment |
| Anritsu faulty keys? For MG3700A vector signal generator. |
| (1/1) |
| drew23:
Hi All I have just bought an Anritsu MG3700A vector signal generator. However, the keys seem either intermittent or don't seem to work at all. I searched the forum for faulty keys on Anritsu gear and found a few people with similar problems but I couldn't find any solution that may have been used. I have yet to get a service manual. I think I can get one once my registration is approved. Regards Drew VK4ZXI |
| jjoonathan:
I had a MG3700A with terrible keys! All I had to do was unscrew things until I could get the blister pad out and then I tossed it in the dishwasher, popped it back in, and was good to go. Your dishwasher might be more aggressive than mine so be careful. |
| drew23:
Thanks. I did much the same. Just cleaned the circuit board and keypads and reassembled the instrument. Now it works fine. Drew VK4ZXI |
| Navigation |
| Message Index |