Products > Test Equipment
Anritsu faulty keys? For MG3700A vector signal generator.
(1/1)
drew23:
Hi All
I have just bought an Anritsu MG3700A vector signal generator. However, the keys seem either intermittent or don't seem to work at all.
I searched the forum for faulty keys on Anritsu gear and found a few people with similar problems but I couldn't find any solution that may have been used.
I have yet to get a service manual. I think I can get one once my registration is approved.
Regards Drew VK4ZXI
jjoonathan:
I had a MG3700A with terrible keys! All I had to do was unscrew things until I could get the blister pad out and then I tossed it in the dishwasher, popped it back in, and was good to go.
Your dishwasher might be more aggressive than mine so be careful.
drew23:
Thanks. I did much the same. Just cleaned the circuit board and keypads and reassembled the instrument. Now it works fine.
Drew VK4ZXI
Navigation
[0] Message Index
Go to full version