Products > Test Equipment
Any Hantek DSO2C15 users here who know how to record the protocol decoder output
(1/1)
shawty:
I have a hantek DSO2C15, I've been decoding and monitoring some I2C data streams on a device under test.
The built in protocol decode, once you set it up is a very useful feature, but the manual is.... well a bit pants to be honest.
I know I can snapshot the screen, and also grab the current wave on screen, but what I really want to do is save out the decoded bytes in the onscreen monitor, preferably in real time if possible.
Anyone know if it's at all possible?
Cheers
Shawty
JohnC:
Better to ask in the main thread here:
https://www.eevblog.com/forum/testgear/new-hantek-dso2x1x-models/
At the top of the page, search the word "Protocol" in "This Topic" :)
DavidAlfa:
Not that I'm aware of. Just get a cheap 8ch 24MHz logic analyzer ($8) and use Sigrok or Saelae software.
shawty:
Thanks John-C, I didn't notice that thread the first time round, dunno how I missed that one.
:-)
shawty:
DavidAlpha... yea I have one of those already, I was just wondering if it was possible using the scope, since I had it all set up and tracing, didn't want to disconnect everything to get the logic analyzer set up :-)
Navigation
[0] Message Index
Go to full version