Products > Test Equipment

RD JDS6600 25MHz 2-Channel DDS AW Function Signal Generator

<< < (21/44) > >>

Marco:

--- Quote from: gby on July 22, 2017, 01:42:56 pm ---It would be great to see some pictures of the insides

--- End quote ---

Don't think we should derail this thread too much, so I put up a pic of the FY6600S in the what did you buy today thread.

PS. using a zoomed in part of triangle wave to check the monotonicity of a function generator with a 8 bit scope was an idea I'm embarrassed to say I didn't even think about.

RD Tech:

--- Quote from: tritutik on September 29, 2017, 02:11:17 pm ---Hi, everybody.
Probably this is some kindof side topic but important.

I would like to make my own program to control JDS6600 (surely specific and simpler than standard), where I can find commands description for JDS? Pls. help.

Another question (JDS is new for me) for sweep frequency mode: is there any syncro signal when JDS starts  change frequensy, how to get it?

Thank you in advance

--- End quote ---
Hi friend
thank you for your question
I am the manufacturer of JDS6600,
Let me answer your question one by one
1, there is communication protocal, you can check the file again , although it is chinese, you can tranlate by googl, if you don't understand some words, you can contact me
2, no ,therer is not

RD Tech:

--- Quote from: caned on October 02, 2017, 03:36:45 pm ---Hi tritutik,

I found a PDF of the command protocol on the included CD. It's in Chinese, so you may have to use Google Translate if you can't read it.

(I tried to copy the filename here, but the Chinese characters didn't come through. If you look in the Chinese folder, you'll see a subfolder with some PDFs in it. The comm protocol PDF is the smallest one, about 288kB.)

caned

--- End quote ---
yes, you are right , thank you

n4axe:
RD Tech, Have any of the indicated issues such as the phase lock with two channels active been rectified? If so / not is this or will this be a hardware or software fix. I am currently shopping for a dds function generator to pair with a new o-scope. Thanks.

RD Tech:
Hi friend
all our problem are fixed and updated
don't worry

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod