Products > Test Equipment
RD JDS6600 25MHz 2-Channel DDS AW Function Signal Generator
<< < (39/44) > >>
malagas_on_fire:

--- Quote from: Jacampb2 on December 18, 2018, 04:33:00 pm ---Well, apparently there was something more going on with this one than the ghost voltage. The attached image is what I got after powering it up this am.  Is there a way to hard reset this thing, or is it just scrap?

--- End quote ---

Check if the last paragraph with the hard reset key works:

https://www.eevblog.com/forum/testgear/anybody-know-anything-about-this-signal-generator/msg2028949/#msg2028949
Jacampb2:
Thank you! I'll give it a shot.
jimanis:
Hello i have  the jds6600 60mhz  model,when i open tha case   i have  see that the ic  is erased!someone knows  what ic  is??
tooki:

--- Quote from: jimanis on February 27, 2019, 11:27:57 pm ---Hello i have  the jds6600 60mhz  model,when i open tha case   i have  see that the ic  is erased!someone knows  what ic  is??

--- End quote ---
Bro... can you be a bit more specific? There are 14 ICs visible in that picture that have at least 8 pins.
jimanis:
all the  ICs  in the box is  erased!very bad  this!Good  meter  but this is problem.. 
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod