Products > Test Equipment

RD JDS6600 25MHz 2-Channel DDS AW Function Signal Generator

<< < (39/44) > >>

malagas_on_fire:

--- Quote from: Jacampb2 on December 18, 2018, 04:33:00 pm ---Well, apparently there was something more going on with this one than the ghost voltage. The attached image is what I got after powering it up this am.  Is there a way to hard reset this thing, or is it just scrap?

--- End quote ---

Check if the last paragraph with the hard reset key works:

https://www.eevblog.com/forum/testgear/anybody-know-anything-about-this-signal-generator/msg2028949/#msg2028949

Jacampb2:
Thank you! I'll give it a shot.

jimanis:
Hello i have  the jds6600 60mhz  model,when i open tha case   i have  see that the ic  is erased!someone knows  what ic  is??

tooki:

--- Quote from: jimanis on February 27, 2019, 11:27:57 pm ---Hello i have  the jds6600 60mhz  model,when i open tha case   i have  see that the ic  is erased!someone knows  what ic  is??

--- End quote ---
Bro... can you be a bit more specific? There are 14 ICs visible in that picture that have at least 8 pins.

jimanis:
all the  ICs  in the box is  erased!very bad  this!Good  meter  but this is problem.. 

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod