Products > Test Equipment
RD JDS6600 25MHz 2-Channel DDS AW Function Signal Generator
<< < (43/44) > >>
Mariocar:
Hi, everyone. Could anyone help me, please? One of the channels in my function generator JDIS6600 has stopped working. I've checked it and verified that the integrated circuit (circled in the attached photo) is causing the issue. Since its identification number has been scratched off, I can't find out its code. Could anyone help me to find out the code so that I can replace it, please? Thank you.
BillyO:
Mine is a 60MHz version and the board is a little different, but in that location there is a chip where the 3rd pin is being fed by a similar tiny 6 pin chip like in yours and it is an AD8056 low noise op-amp.

On yours you can see the tops of those characters, so it's pretty much what it is.

Good luck!

BTW, you can also see that in post 10 of this thread.
Mariocar:
Thank you.
lushprojects:
Very quick and dirty project to add a web interface to at least a few functions of the JDS6600:
https://github.com/sharpie7/jds6600web
RobbiOne:
JDS6600 60MHz ... the main board rev. 18 seems different from the previous ones. For only 52€ on Amazon it was a real bargain indeed.  😁
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod