Products > Test Equipment
RD JDS6600 25MHz 2-Channel DDS AW Function Signal Generator
<< < (9/44) > >>
pascal_sweden:

--- Quote from: pantelei4 on July 13, 2017, 12:32:26 pm ---The device has a very poor Electromagnetic compatibility,
Interference is caused by DC / DC motherboard converters.
This is noticeable immediately after switching on, if we put a probe next to it.
Sensitivity 500uV / div
Bandwidth 300MHz
The probes of the oscilloscope are connected to ground, there is no signal at the input,  noise JDS6600  is very high.

--- End quote ---

Maybe it's because of your lousy way of connecting the probes to the signal generator.

Why on Earth don't you have decent BNC cables?

First time that I see a Rigol DS2000A user (supposed to be professional player) without decent cables :)
pantelei4:

--- Quote from: pascal_sweden on July 14, 2017, 07:37:42 pm ---Maybe it's because of your lousy way of connecting the probes to the signal generator.

--- End quote ---
Of course yes.
If you turn on the bandwidth of 20MHz, interference will become significantly less.
But connected in the same way to the MHS5200A, with a full bandwidth there is no interference from the DC / DC converters of the motherboard.
The JDS6600 has a noise of the ground, With a repetition rate of 400kHz and a spectrum wider than 100MHz. I consider this a design error. The video was shot specially to show it.
pantelei4:

--- Quote from: pascal_sweden on July 14, 2017, 07:37:42 pm ---First time that I see a Rigol DS2000A user (supposed to be professional player) without decent cables :)

--- End quote ---
I'm not a professional, just an amateur. :)
Two signals, small approximately equal level.
Yes, the ground clamp loop catches radio interference, which creates a power source.
Now I need to think about how to reduce EMI, when the developer should take care of it.
JDS6600
Analog no name.
pascal_sweden:
If I am correct, the actual designer of this signal generator is in this thread. Maybe you can PM him with your suggestions to further improve the design.

I will wait ordering the device until the Mark II version becomes available :)
pantelei4:

--- Quote from: pascal_sweden on July 14, 2017, 10:40:06 pm ---If I am correct, the actual designer of this signal generator is in this thread. Maybe you can PM him with your suggestions to further improve the design.

--- End quote ---
Probably the designer needs to study AN139 - Power Supply Layout and EMI
http://cds.linear.com/docs/en/application-note/an139f.pdf
Why should I pay for other people's mistakes, and then help solve the problem?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod