Products > Test Equipment
Anyone have a Cami Research CableEye M2 M3 M2+ M3+ Cable Tester?
KG7AMV:
I have a Cami Research CableEye M2 Cable Tester on the way. I will do a teardown of it.
I have not received the machine yet will be here any day. I have registered the unit and have downloaded the software V4.3.15 Anyone have a later version of the software?
I just Received my 1st set of Connector Boards for some cables I plan on testing.
I have also started on making the connector board PCB footprint. I will post the easyeda project files on my blog once I get the fit fine tuned!
KG7AMV:
I have started the teardown. Not Much to it inside.
Messtechniker:
Not much to it? Some 80+ chips and some 20 resistor arrays plus all the other stuff.
Easy to build yourself. |O
KG7AMV:
Except for the PAL pretty sure it's going to be locked.
KG7AMV:
Snagged a M3U the other day... It Should be arriving Thursday the 22nd or Friday the 23rd
I now have Version V5.3 Thats the Version the M3U was Shipped with.
I Noticed in settings it Listed the M2 so I plugged it in and detected it.
I have to say V5.3 is better then the V4.3
Someone out there must have newer software? Latest Version is V6.2 B-1905
Cable I Made for my Data I/O 29B.
Navigation
[0] Message Index
[#] Next page
Go to full version