Products > Test Equipment
Anyone here familiar with a Seica Pilot VX flying probe system?
(1/1)
PeterFW:
Recently i had the oportunity to work on a Seica Pilot VX.

I had a look at the userinterface and a chance to play with it a little bit and the more i think about it the more something bugs me about.

And i just remembered why it looked so familiar...

That is a spice window in the schematic view, right?
Am i right in assuming that this marvellous machine performs a complete circuit simulation on the backend which it then uses to perform offset calculations/compensations on the in circuit test?

If not, can someone expain this to me like a toddler?

Like, i get the motion stage, i can use all the usual test equipment it has in it on its own.
By the way, those linear magnet actuators on the probe heads are super cute!
I got a 3D printer, can do embedded C, CAD, CAM, 0201 hand soldering... all been there.   
I know how a needle test bed works and how to design one, all good.

But i can not wrap my head around this, it looks like magic and it makes me feel stupid.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod