Products > Test Equipment

Applent AT825 calibration

(1/3) > >>

Veketti:
Dear All,

I just bought some high precision resistors and noticed that my AT825 is showing 0.45ohm too small value. I confirmed this with bench multimeter by 4 wire measurement. Is there any way to adjust AT825 to show correctly, other than sending the meter to China? I've done the open and short calibration but that didn't help.

Thank you in advance.

Bud:
The high precision resistors are made in China by any chance?

Veketti:
Haha, no. Vishay Dale MR100 series from Digikey.

Kean:
Did you try the "Short Correction" function?

Veketti:

--- Quote from: Kean on March 26, 2023, 08:20:27 am ---Did you try the "Short Correction" function?

--- End quote ---

Yes, as well as the open correction function.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod