Products > Test Equipment
Are there any hacks for Siglent 3303x-e power supply?
n3mmr:
I thought I saw a mention of a hack for the FW of the Siglent 3303X-E power supply to enable 1mV set and readout accuracy, or at least 1mV resolution.
Does such a hack actually exist?
tv84:
https://www.eevblog.com/forum/testgear/siglent-ads-firmware-file-format/msg1830584/#msg1830584
tautech:
--- Quote from: n3mmr on February 17, 2019, 12:20:09 pm ---I thought I saw a mention of a hack for the FW of the Siglent 3303X-E power supply to enable 1mV set and readout accuracy, or at least 1mV resolution.
Does such a hack actually exist?
--- End quote ---
Sure does, tv84 linked it. ;)
Even for the X-E model, 1mV and 1mA resolution is available within the EasyPower software.
rolfdegen:
Hallo siglent users
I hacked my new Siglent SPD3303X-E in to SiglenSPD3303X . I am verry happy :-+
Its verry easy:
First installed EasyPower from Siglent on my Win10 System
Then I install NI-VISA from National Instruments
Than start EasyPower
After that connect a LAN or USB cable
Press Connect symbol under Menu "File" and set in EasyPower 0.001V CH1 (press "Set)
Now press menu "Version" > "Upgrade" > "Normal Mode" > "UpgradeFile" and load firmware file "SPD3303X-1.01.01.02.05_ConvertFromX-E" and press "Upgrade" and wait a little bit to upgrade file (see a blue line on LCD screen to Siglent power supply). After this press ok and the Power Supply restart automatically.
It is very simple and nice. Thanks a lot :-+
My Siglent SPD3303X-E with 1mV and 1mA
Greetings from germany. Rolf
boggis the cat:
--- Quote from: rolfdegen on March 11, 2020, 08:19:32 pm ---It is very simple and nice. Thanks a lot :-+
--- End quote ---
Thank you for the instructions. Worked fine on a new SPD3303X-E.
:-+
Navigation
[0] Message Index
[#] Next page
Go to full version