| Products > Test Equipment |
| ARRAY electronic loads |
| << < (22/30) > >> |
| VK5RC:
On 'fleabay' the 3721 goes for about $900. Regards Rob |
| nctnico:
I got mine through Ebay as well. I can sum up the the software which comes with the dummy loads with two words: useless crap. |
| HighVoltage:
I have a BK Precision 8500 and a Maynuo 9811 And I can highly recommend any one of those two instruments. Somehow, I like the Maynuo a little more, because it has 2 lines and 4 numbers at the same time in the display. So, watching voltage, current and power at the same time, is sometimes a little benefit And the software on both systems works great. For a lower end project, I needed a low cost solution and ended up with several 100 W power resistor, instead of a DC load. Because I did not like the lower cost units at all. |
| Circuitous:
I have a couple of Array loads, 3723A and 3710A. I like that they can display 4 attributes at once (unlike the BK) but the PC software isn't great and it has a crappy TTL interface (not RS-232 or USB) that requires an adapter (you can make your own). The backlit LCD on the 3723A is clear and bright, easy enough for me to read from 3 feet away. But, I still would prefer a VFD. If I was starting over, I'd probably get the Maynuo. I may pick up a M98xx later this year. |
| MarkL:
--- Quote from: Circuitous on March 14, 2014, 01:03:18 pm ---I have a couple of Array loads, 3723A and 3710A. I like that they can display 4 attributes at once (unlike the BK) but the PC software isn't great and it has a crappy TTL interface (not RS-232 or USB) that requires an adapter (you can make your own). --- End quote --- The 3723A has an isolated, true RS-232 inteface. No adapter needed. |
| Navigation |
| Message Index |
| Next page |
| Previous page |