Products > Test Equipment

ARRAY electronic loads

<< < (14/30) > >>

saturation:
Final burn in report:

The Array 3710a has been running ~ nonstop for almost 3 weeks, 24/7, and all the internal components are holding <= 50% of their rated operating temperature whether quiescent or under load.  This speaks well for long term durability.  The power MOSFETs are held at 40C or less.  I've also finished over 20+  hours of load testing, 4 cycles each of 2x NiMH battery packs drawing between 20-40W each, and the interior temps stay <= 40C while operating at room temperature 25C, fans kick in as needed and do a good job in cooling.



saturation:
I ran into this today:

https://www.tmatlantic.com/e-store/index.php?SECTION_ID=367

Another Array rebrand for USA buyers.  The newer model is the lowest price so far I've seen for the 372x series.

T4P:
A whole new design with 250W for the base model  :P At least they addressed the lack of CV and added a shitload of modes
I guess it isn't designed by Xiao Tony right?

saturation:
The AEL-8321 is likely the higher end 400W model, Array 3721a.  I hope someone one day tears it down, because it appears to have different capabilities from the BK, Maynuo or Itech models 85xx series.  Anyone can compare just searching tabao.com that the price is very competitive with local China prices, particularly once you add in S&H, so if they charge more it might be made quite differently, better I hope.

Spec wise the AEL-8310 appears as the Array 3710a entirely.





--- Quote from: T4P on October 01, 2012, 12:40:08 pm ---A whole new design with 250W for the base model  :P At least they addressed the lack of CV and added a shitload of modes I guess it isn't designed by Xiao Tony right?

--- End quote ---

LaurenceW:
... and the numeric keypad is laid out properly - Hurrah!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod