Author Topic: Atorch DL24 Electronic load software  (Read 5730 times)

0 Members and 1 Guest are viewing this topic.

Offline Grandchuck

  • Frequent Contributor
  • **
  • Posts: 296
  • Country: us
Re: Atorch DL24 Electronic load software
« Reply #25 on: June 12, 2021, 01:38:52 pm »
Atorch DL24 is on COM3 and Device Manager reports it is working properly.
But, test controller is not happy:
   ;; COM3: Set params: 9600
   ;; COM3: Tx: <*IDN?.> 2A 49 44 4E 3F 0A
   ;; COM3: Rx: timeout, in buffer: FF 55 77 DE 3C 92
   ;; COM3: Tx: <*IDN?.> 2A 49 44 4E 3F 0A
   ;; COM3: Rx: timeout, in buffer: FF 55 77 DE 3C 93
   ;; Stopping thread for: COM3
   ;; COM3: Close
I have tried and retried reinstalling the driver; nothing changes.  Any ideas?
 

Online HKJ

  • Super Contributor
  • ***
  • Posts: 1936
  • Country: dk
    • Tests
Re: Atorch DL24 Electronic load software
« Reply #26 on: June 12, 2021, 03:15:27 pm »
Atorch DL24 is on COM3 and Device Manager reports it is working properly.
But, test controller is not happy:
   ;; COM3: Set params: 9600
   ;; COM3: Tx: <*IDN?.> 2A 49 44 4E 3F 0A

You have to add "ATorch DL24" on the "Load devices" page, set the com port, enable it and press Reconnect.
A checkmark in "Scan serial ports" only works with SCPI devices.
 

Offline Grandchuck

  • Frequent Contributor
  • **
  • Posts: 296
  • Country: us
Re: Atorch DL24 Electronic load software
« Reply #27 on: June 12, 2021, 03:56:34 pm »
Ahhh ... I set the COM port and it is working.  Thick skull here |O

Thanks much!
 

Online HKJ

  • Super Contributor
  • ***
  • Posts: 1936
  • Country: dk
    • Tests
Re: Atorch DL24 Electronic load software
« Reply #28 on: June 12, 2021, 04:15:15 pm »
Ahhh ... I set the COM port and it is working.  Thick skull here |O

You are not the first, the red background is obvious not enough, I will think about how I can improve it.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf