Products > Test Equipment
Atorch DLB-600W DC load
(1/1)
Odd:
Hi, I purchased a DLB-600W from Atorch on Aliexpress.

The load can be connected using kelvin probes.
I heard a loose part inside - it was a 1cm wide 6-turn coil on 0.9mm wire. it's resistance is 50mOhm
Atorch support told me it was mounted internally between I- and V- inputs as a "reverse polarity protection"

Having it there clearly destroys half of the precision gained by having sensing leads.

1. Does anyone know exactly what it is supposed to protect? - I can only assume it is against connecting V- to V+ or so.
2. if you have one, and do not remove it : do know that the precision is compromised. - the factory calibration of the device is otherwise very good.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod