Author Topic: ATTEN ATF20B teardown  (Read 44595 times)

0 Members and 1 Guest are viewing this topic.

Offline BeJay

  • Contributor
  • Posts: 12
  • Country: au
Re: ATTEN ATF20B teardown
« Reply #50 on: January 27, 2013, 02:59:54 pm »
"There I fixed it!" - ok, so there is still a lot of flux on the board, and the bodge wires are a little big, but bugger me it works just like when I bough it... Cheers for the help fellas I'm off to make a protection circuit now ;)
 

Offline SeanB

  • Super Contributor
  • ***
  • Posts: 15472
  • Country: za
Re: ATTEN ATF20B teardown
« Reply #51 on: January 27, 2013, 04:05:56 pm »
Low impedance.........

Clean off the flux and it will look like it did straight from the factory.

What are you going to use for protection? A pair of  IDC clips and some 50mA sub miniature wire ended fuses to go in them?
 

Offline (In)Sanity

  • Regular Contributor
  • *
  • Posts: 229
  • Country: us
Re: ATTEN ATF20B teardown
« Reply #52 on: January 27, 2013, 05:55:22 pm »
It's not what it looks like,  it's how it works.   Nice job.
 

Offline mbdemello

  • Newbie
  • Posts: 2
Re: ATTEN ATF20B teardown
« Reply #53 on: June 08, 2014, 09:33:45 pm »
Hi!  I created a new topic on  ATF20B, regarding a ATF20B main-board (FPGA) failure and  would like to know if you have some schematics or block diagram of that generator.
Thanks and regards,

Mauricio De Mello
 

Offline Solder_Junkie

  • Regular Contributor
  • *
  • Posts: 73
  • Country: gb
Re: ATTEN ATF20B teardown
« Reply #54 on: October 09, 2015, 01:34:44 pm »
I came across this old thread recently and a general lack of info on these cheap Chinese function generators. There have been some on eBay UK for £188.77 inc tax and delivery (from a UK address). The price is as low as it gets...

Attached is the English manual for these, if it's of use to anyone considering one.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf