| Products > Test Equipment |
| Ballantine 3205B Microhm meter |
| << < (4/5) > >> |
| don.r:
--- Quote from: Shock on November 29, 2019, 09:49:17 pm ---That Ballantine 3205B has a Fluke or Keithley vibe to it. --- End quote --- The Ballantine screams Keithley with the red LED display and rectangular bush button front. The handle even fits the Keithley 485 that I'm working on atm perfectly and has a similar Keithley brown tone to it. |
| don.r:
Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted. |
| Shock:
--- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted. --- End quote --- C9 looks Tantalum where is the far right one? |
| don.r:
--- Quote from: Shock on December 08, 2019, 09:34:00 pm --- --- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted. --- End quote --- C9 looks Tantalum where is the far right one? --- End quote --- Good catch. C9 needs to go too. The cap in question is the large blue electrolytic on the far right in Vgkid's third picture. Mine is a tant. |
| Vgkid:
--- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted. --- End quote --- Good job. My case is yellow, unfortunately epoxy was spilled on the top case. |
| Navigation |
| Message Index |
| Next page |
| Previous page |