Products > Test Equipment

Ballantine 3205B Microhm meter

<< < (4/5) > >>

don.r:

--- Quote from: Shock on November 29, 2019, 09:49:17 pm ---That Ballantine 3205B has a Fluke or Keithley vibe to it.

--- End quote ---

The Ballantine screams Keithley with the red LED display and rectangular bush button front. The handle even fits the Keithley 485 that I'm working on atm perfectly and has a similar Keithley brown tone to it.

don.r:
Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted.

Shock:

--- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted.

--- End quote ---

C9 looks Tantalum where is the far right one?

don.r:

--- Quote from: Shock on December 08, 2019, 09:34:00 pm ---
--- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted.

--- End quote ---

C9 looks Tantalum where is the far right one?

--- End quote ---

Good catch. C9 needs to go too. The cap in question is the large blue electrolytic on the far right in Vgkid's third picture. Mine is a tant.

Vgkid:

--- Quote from: don.r on December 08, 2019, 08:57:19 pm ---Finally had time to revisit this. After cleaning the switches ... it works like a champ! Rock solid and accurate on all ranges with a nice bright LED display. In mine the cap on the far right of the display board is a tantalum so that will have to go. Other than that its a case of case restoration and some new shrouded sockets to be retrofitted.

--- End quote ---
Good job. My case is yellow, unfortunately epoxy was spilled on the top case.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod