Products > Test Equipment

Banggood 50 ohm BNC feed-through terminator - a quick review

<< < (8/15) > >>

alm:
Got a pair to have some extra around. One of them came apart while disconnecting a BNC cable. Guess they ran low on both thread locker and 100 Ohm resistors :P.

Gyro:
More likely, the assembly instructions called for three 150R resistors spaced at 60' and the poor, underpaid, assembler realised that he/she could save a few seconds by stacking two of them.

CJay:
At least they filed through the nickel or chrome to get to the brass underneath for soldering

Gyro:
Hence the time saving - and probably the loosening too. Less burrs on the threads to make it tight.

alm:

--- Quote from: Gyro on July 23, 2017, 09:47:06 am ---More likely, the assembly instructions called for three 150R resistors spaced at 60' and the poor, underpaid, assembler realised that he/she could save a few seconds by stacking two of them.

--- End quote ---
Unlikely in my opinion, given the earlier pictures that showed two 100 Ohm resistors at 180° spacing.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod