Products > Test Equipment
Bench LCR Recommendations?
<< < (16/16)
KungFuJosh:

--- Quote from: pope on June 02, 2023, 07:26:10 pm ---
--- Quote from: KungFuJosh on June 02, 2023, 03:03:07 pm ---What mains fuses do you have in your TH2830 using 120VAC? It occurred to me I probably need to change it since this was setup for 220V.

Thanks,
Josh

--- End quote ---

Assuming the fuse value is correct for the 220VAC, I would use a 2x this value for 120vac.

--- End quote ---

Thanks. I too assumed this, but since I don't know if the fuse value is correct, I figured I should ask. 😉

EDIT: I'm just going to leave the 500mA slow blow that was in there. It seems to run fine with it, and that already seems high compared to my DMM. My DMM doesn't specify different fuses for different wall voltage. 🤷
KungFuJosh:
So, this is dumb, but anyway... The other day I figured out you don't need to go to the setup menu to make changes to the measurement choices. You can do that by moving the arrows on the measurement screen. Oh well. I know, RTFM, but also, meh. 😉

This is awesome, because the extra steps in some of the other models I was considering is what helped me choose the TH2830.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod