Products > Test Equipment
Best CHEAP LCR meter for small capacitors and inductors?
<< < (6/13) > >>
Martin72:

--- Quote ---Other question - is it normal to do calibration on DE-5000 every time you turn it on?
--- End quote ---

Depends on how accurate you want to have the measures.
Ambient temperature/humidity are changing plus warmup of the meter itself.
thm_w:
If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

tautech:

--- Quote from: thm_w on November 23, 2022, 12:47:50 am ---If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

--- End quote ---
Why ?
To be properly equipped you need both.
thm_w:

--- Quote from: tautech on November 23, 2022, 01:06:20 am ---
--- Quote from: thm_w on November 23, 2022, 12:47:50 am ---If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

--- End quote ---
Why ?
To be properly equipped you need both.

--- End quote ---

Just because its not entirely clear what OP is doing.
If its in circuit measurement then the tweezers are great to have. If its measuring a part, very precisely, prior to install, then maybe the mentioned SMD jig with a DE-5000 would be more repeatable.
ranchero:

--- Quote from: thm_w on November 23, 2022, 01:47:06 am ---Just because its not entirely clear what OP is doing.
If its in circuit measurement then the tweezers are great to have. If its measuring a part, very precisely, prior to install, then maybe the mentioned SMD jig with a DE-5000 would be more repeatable.

--- End quote ---

I don't think it's even possible to measure such small values correctly in-circuit. So - I always remove them. The tweezers you've recommended only go up to 10kHz, so they will not measure small inductors.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod