Products > Test Equipment

Best CHEAP LCR meter for small capacitors and inductors?

<< < (6/13) > >>

Martin72:

--- Quote ---Other question - is it normal to do calibration on DE-5000 every time you turn it on?
--- End quote ---

Depends on how accurate you want to have the measures.
Ambient temperature/humidity are changing plus warmup of the meter itself.

thm_w:
If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

tautech:

--- Quote from: thm_w on November 23, 2022, 12:47:50 am ---If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

--- End quote ---
Why ?
To be properly equipped you need both.

thm_w:

--- Quote from: tautech on November 23, 2022, 01:06:20 am ---
--- Quote from: thm_w on November 23, 2022, 12:47:50 am ---If you didn't already have the DE-5000 then I would say consider these: https://shannontweezers.top/

--- End quote ---
Why ?
To be properly equipped you need both.

--- End quote ---

Just because its not entirely clear what OP is doing.
If its in circuit measurement then the tweezers are great to have. If its measuring a part, very precisely, prior to install, then maybe the mentioned SMD jig with a DE-5000 would be more repeatable.

ranchero:

--- Quote from: thm_w on November 23, 2022, 01:47:06 am ---Just because its not entirely clear what OP is doing.
If its in circuit measurement then the tweezers are great to have. If its measuring a part, very precisely, prior to install, then maybe the mentioned SMD jig with a DE-5000 would be more repeatable.

--- End quote ---

I don't think it's even possible to measure such small values correctly in-circuit. So - I always remove them. The tweezers you've recommended only go up to 10kHz, so they will not measure small inductors.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod